Metrosoft CM certification
PTB certified evaluation software
Our evaluation algorithms have been tested by the Federal Physical and Technical Institute (PTB).
 |
All results of the tested software show a deviation from the PTB reference values of less than 0.1µm (0.0001mm) in units of length and 0.1" in units of angle and are classed amongst the smallest deviations.
The accuracy of the evaluation software has been confirmed using a comparison of calculated results with reference results of the PTB. The calculation of the parameters submitted to PTB has been conducted using Metrosoft CM 3.50.
The same algorithm is used in Metrosoft CM 3.100, 3.90, 3.80, 3.70 and 3.60 as in CM 3.50.
A new audit by the PTB will be initiated as soon as there will be any change in the source code of the evaluation algorithm.
Navigation
CM News
- Service Pack 2 Metrosoft CM 3.90 27.09.11 - The service pack 2 for Metrosoft CM is available and can be downloaded under "Metrosoft CM > Downloads".
- Metrosoft CM 3.100 23.12.10 - The new Metrosoft CM 3.100 version has been released and therefore is available for everybody.